Futaba 8SGAP User Manual download pdf (Page 10)

MODE I

Slantable stick adjusting screws

The angle of the stick levers can be changed.

Fig.

3

Turn this screw with a Phillips

screw-driver.

The open gimbal stick

angle can be adjusted from

about 3° to the inside to

4.5° to the outside by

turning the adjusting screw

as shown in the figure.

Adjust the stick to the

most comfortable angle.

Phillips screwdriver

The strength of the stick lever spring can be ad-

justed.

Remove these

screws, and

remove the

back cover.

Fig.

4

Fig.

5-A

Elevator

Rudder

Aileron

Turn with a Phillips screwdriver.

The spring strength can be adjusted as desired by

removing the transmitter back cover and turning

the adjusting screw of each stick. Adjust the spring

strength for the best stick feel.

MODEII

Remove the three screws shown and remove the

transmitter righthand side panel as shown in

Fig. 5-B.

Displace the side panel away from the case.

(slide down-off)

Disconnect the power connector.

Adjust the spring tension.

Cautions

• Be sure that the PC board attached to the side

panel does not touch the transmitter case.

• Disconnect the power connector before side

panel completely off, while side down-ward,

to avoid touching with TX case.

•When the power connector is disconnected,

the memorized contents (ATV, FS, etc.) are

cleared. When flying again, reset the contents.

Elevator

Fig. 5-B

The side panel can

be removed by

removing these

three screws.

Aileron

Rudder

Power connector

Transmitter RF module

• Change this module when

switching frequency bands

(50, 53, 72, and 75MHz).

A temperature rise at the

RF module section during

use is normal.

Fig.

6

Transmitter

crystal

While pushing this tab to the

inside, pull the RF module forward.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 37 38

Comments to this Manuals

No comments