Futaba CGY750 User Manual download pdf (Page 16)

(1) Start display

The editing menus are scrolled

by pushing the mode + or – key.

(2) Revolution setting

[range: 700



4000

rpm]

Setting the main rotor revolution. This is calcu-

lated by engine revolution with the gear ratio of

the main shaft.

(3) Gear ratio

[default: 8.00, range: 1



50]

Input the main rotor gear ratio by pushing the

data + or-key.

OVERNOR

ASIC

ETTING

*It does not display, when Opr.mode is

Gyro+THR, and when SWASH-type is

H4-00/H4-45.

*It does not display, when Opr.mode is

Gyro+THR, and when SWASH-type is

H4-00/H4-45.

*It does not display, when Opr.

mode is Gyro+THR, and when

SWASH-type is H4-00/H4-45.

*It does not display, when Opr.

mode is Gyro+THR, and when

SWASH-type is H4-00/H4-45.

7KLVPHQXVHWVWKHJRYHUQRU¶VIXQGDPHQWDOIXQFWLRQV7KHPHQXServo

limit point settingPXVWEHVHW¿UVW

(5) Servo selection

[default: Analog]

Select the throttle servo type. Digital servos of-

fer the best response. The type is changed by

pushing data + or – key.

(6) Stick switch

[default: 30%]

The governor can be activated by throttle stick

position. Move the throttle stick to the desired

governor on position and push SET key, memo-

rizing that point. When you push the RSET key,

the function is inhibited. When the governor on/

off switch is inhibited, the stick switch is auto-

matically turned on.

(4) Pole number [default: 2p, range: 2p



24p]

This function sets the motor pole count. This function is used when employing a direct phase

sensor attachment to a brushless motor lead. Input the motor pole count as speciﬁed by the

brushless motor manufacturer. When using any revolution sensor other than a direct phase sen-

sor type, set the pole number to 2p.

NOTE: The input signal range of the CGY750 is 0.0v-3.0v. Exceeding this voltage range may

cause damage to the CGY750.

GOVERNOR BASIC

MAP. 1

WARNING

This parameter must match the type of

servo you are using. Incorrect setting may

damage the CGY750 or the servo, possibly

resulting in a loss of control during ﬂight.

****Please see the Governor EXPERT menu in the ADVANCED TUNING SECTION at

the end of this manual for additional guidelines for governor use with electric models.

Push

DATA

+/– key

Push

DATA

– key

Push

DATA

+ key

Push

MODE

+/– key

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 26 27

Comments to this Manuals

No comments

Futaba CGY750 User Manual Page 16

Comments to this Manuals

Related products and manuals for Measuring instruments Futaba CGY750