Futaba 9VHP User Manual download pdf (Page 9)

•BASIC TRANSMITTER T9VHP CONTROLS

Refer to the fold-out illustration at the back of the manual.

Aileron Control (Right and Left Cyclic on

helicopter)

Elevator Control (Fore and Aft Cyclic on

helicopter)

Throttle Control (Throttle and Collective

Pitch (T/C) on helicopter)

Rudder Control (Tail rotor on helicopter)

CH5 Switch Multiple uses depending on pro-

gramming by modeler.

• Landing Gear (fixed wing aircraft)

• Rate gyro output sensitivity switching (heli-

copter)

•COMBI Switch - Rudder offset, Idle-Up.

and Dual rate can be turned ON and

OFF.

• Inverted flight switch

Hovering Pitch

Lever — left side of transmitter

CH6 Control Lever (In BASIC mixing mode)

Aileron Dual Rate ON/OFF Switch

Elevator Dual Rate ON/OFF Switch

Rudder Dual Rate ON/OFF Switch

NOTE: Functions of the D/R switches can

be selected, combined, ON/OFF directions

changed, etc. (See

page 46)

Revolution Mixing (Pitch ->• Rudder Mixing)

UP Side Knob

Revolution Mixing (Pitch -> Rudder Mixing)

DOWN Side Knob

Idle-up 1 ON/OFF Switch

Idle-up 1 Knob

Idle-up 2 ON/OFF Switch

Idle-up 2 Knob

Hovering Throttle Trim Knob

Throttle Hold Switch

Pitch control servo

total travel

Throw can be adjusted within this range

with the lever when the throttle stick is in

the neutral position.

CH7 Control Knob Pitch Trim Knob (If func-

tion

activated)

CH8 Control Switch COMBI Switch (if se-

lected) - RUD offset, Idle-Up, and D/R ON/

OFF

Aileron Trim Lever

Elevator Trim Lever

Throttle (ATL) Trim Lever

LOW

HIGH

Servo travel by

throttle trimming

— right side of trans-

12 Rudder Trim Lever

13 High Pitch

Trim

Lever

mitter

Non-Slip Adjustable Control Sticks

The length of the control sticks can be ad-

justed to suit operator preference.

Unlock

Parts

A

andB

by turning them in op-

posite directions as indicated by the arrows,

and adjust the control stick to the most com-

fortable length.

Adjustable Stick Angle

The horizontal angle of the control sticks

can be adjusted.

Phillips

Screwdriver

Turn this screw with a

Phillips screwdriver.

The open gimbal stick angle

can be adjusted from about

3° to the inside to 4.5° to

the outside by turning the

adjusting screw as shown.

Adjust the control stick to

the most comfortable angle.

[7]

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comments to this Manuals

No comments