Futaba 14MZ User Manual Page 7
- Page / 127
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Lithium-ION Battery Safety and Handling instructions
It is important to understand the operating characteristics of lithium-ion (Li-Ion) batteries. Always read the specifications
printed on the label of your Li-Ion battery and charger prior to use. Failure to follow the proceeding precautions can
quickly result in severe, permanent damage to the batteries and its surroundings and possibly result in a FIRE!
IMPORTANT PRECAUTIONS
Do not attempt to disassemble Li-Ion packs or cells.
Do not allow Li-Ion cells to come in contact with moisture or water at any time.
Always provide adequate ventilation around Li-Ion batteries during charge, discharge, while in use, and during
storage.
Do not leave a Li-Ion battery unattended at any time while being charged or discharged.
Do not attempt to charge Li-Ion batteries with a charger that is NOT designed for Li-Ion batteries, as permanent
damage to the battery and charger could result.
Always charge Li-Ion batteries in a fireproof location. Do not charge or discharge Li-Ion batteries on carpet, a
cluttered workbench, near paper, plastic, vinyl, leather or wood, or inside an R/C model or full sized automobile!
Monitor the charge area with a smoke or fire alarm, and have a lithium-approved “ABC type” fire extinguisher
available at all times.
Do not charge Li-Ion batteries at currents greater than the “1C” rating of the battery (“C” equals the rated capacity of the
battery).
Do not allow Li-Ion cells to overheat at any time! Cells which reach greater than 140 degrees Fahrenheit (60
o
C)
should be placed in a fireproof location.
It is normal for the batteries to become warm during charging, but if the charger or battery becomes excessively hot
disconnect the battery from the charger immediately!! Always inspect a battery which has previously overheated for
potential damage, and do not re-use if you suspect it has been damaged in any way.
Do not use a Li-Ion battery if you suspect physical damage has occurred to the pack. Carefully inspect the battery
for even the smallest of dents, cracks, splits, punctures or damage to the wiring and connectors. DO NOT allow the
battery’s internal electrolyte to get into eyes or on skin—wash affected areas immediately if they come in contact with
the electrolyte. If in doubt, place the battery in a fire-proof location for at least 30 minutes.
Do not store batteries near an open flame or heater.
Do not discharge Li-Ion batteries at currents which exceed the discharge current rating of the battery.
Always store Li-Ion cells/packs in a secure location away from children.
Compact Flash (CF) Card Handling Instructions
Follow these precautions when handling the CF card included in your 14MZ transmitter.
IMPORTANT! The Lithium-Ion (Li-Ion) batteries included in the 14MZ transmitter are not to be confused with
Lithium-Polymer (LiPo) batteries, or any other type of rechargeable battery (including NiCd’s and NiMH’s). Li-Ion
batteries require special charging criteria different than other rechargeable batteries. Use only the Futaba lithium ion
transmitter charger included with this set for, or other chargers approved by Futaba to charge the Li-Ion batteries in
the 14MZ transmitter.
Never remove the CF card or turn off power while
entering data.
Never store the CF card where it may be subject to
strong static electricity or magnetic fields.
Do not expose the CF card to direct sunlight, excessive
humidity or corrosive environments.
Do not expose the CF card to dirt, moisture, water or
fluids of any kind.
Always hold the CF card by the edges during installa-
tion and removal.
Be certain to insert the CF card in the correct direction.
- INSTRUCTION MANUAL 1
- TABLE OF CONTENTS 2
- INTRODUCTION 4
- IN NORTH AMERICA 4
- OUTSIDE NORTH AMERICA 4
- Definitions of Symbols 6
- BEFORE USE 9
- <Before Use> 11
- Transmitter controls 13
- Receiver nomenclature 22
- (Helicopter)(Airplane/Glider) 23
- ●Use rubber band to stretch 23
- BASIC OPERATION 24
- Home screen 28
- Music playback 29
- SYSTEM MENU 30
- Student mode 32
- Date and Time 34
- User Name 35
- H/W Reverse 37
- Information 38
- MODEL BASIC SETTING PROCEDURE 39
- Use in rolls 41
- Use in auto rotation 41
- C. Pitch to RUD mixing (Hold) 44
- ●Other settings 44
- FUNCTIONS OF LINKAGE MENU 50
- Servo Monitor 51
- Model Select 52
- Model Type 53
- Picture 55
- Frequency 58
- Function 59
- Trim change 60
- <Linkage Menu> 60
- Sub-Trim 61
- Servo Reverse 62
- Fail Safe 63
- End Point (ATV) 64
- Throttle Cut 65
- Idle Down 66
- <Lap time list> 69
- Dial Monitor 70
- Data Reset 71
- MODEL MENU (COMMON FUNCTIONS) 72
- Condition Select 73
- AFR (D/R) 75
- Prog. Mixes 77
- Setting methods 78
- Fuel Mixture 79
- Model Menu functions list 80
- ( ) 81
- AIL Differential 82
- Flap setting 83
- AIL to Camber FLP 84
- AIL to Brake FLP 85
- AIL to RUD 86
- Airbrake to ELE 87
- RUD to AIL 88
- Camber Mix 89
- Setting method 90
- ELE to Camber 91
- Camber FLP to ELE 92
- Butterfl y 93
- ● Mixing curve setting 94
- ● Servo speed setting 94
- Trim Mix 1/2 95
- Airbrake 97
- Ailevator 101
- ( ) 102
- RUD to ELE 104
- Snap Roll 105
- Multi Engine 106
- MODEL MENU (HELICOPTER) 107
- PIT Curve/Pitch Trim 108
- ● Hovering pitch 109
- ● Low/High pitch trim 109
- ● Adjusts the adjusting dial 109
- ● Return to Model Menu 109
- THR Curve/Throttle Hover trim 111
- Throttle Hover trim 112
- Acceleration Mixing 113
- Throttle Hold 114
- Swash mixing 115
- Throttle mixing 116
- PIT to Needle mixing 117
- Gyro mixing 119
- Governor mixing 120
- Curve setting operation 123
- Switch selection method 126
Related products and manuals for Accessories communication Futaba 14MZ
(2 pages)© 2020, manymanuals.com. All rights reserved. | 0.104 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals