Futaba 3VCS User Manual download pdf (Page 6)

For Your Safety As Well As That Of Others

Operation Precautions

Warning

Prohibited Procedures

Do not operate two or more models

on the same frequency at the same

time.

Operating two or more models at same time on the

same frequency will cause interference and loss of

control of both models.

AM, FM (PPM) and PCM are different methods

of modulation. Nonetheless the same frequency

can not be used at the same point in time, regard-

less of the signal format.

Do not operate outdoors on rainy

days , run through puddles of water or

when visibility is limited.

Should any type of moisture (water or snow) enter any

compoent of the system, erratic opreation and loss of

control may occur.

Do not operate in the following

places.

-Near other sites where other radio control

activity may occur.

-Near people or roads.

-On any pond when rowboats are present.

-Near high tension power lines or communi-

cation broadcasting antennas.

Interference could cause loss of control . Improper in-

stallation of your Radio Control System in your model

could result in serious injury.

Do not operate this R/C system when

you are tired, not feeling well or under

the influence of alcohol or drugs.

Your judgment is impaired and could result in a dan-

gerous situation that may cause serious injury to

yourself as well as others.

Mandatory Procedures

Extend the transmit-

ter antenna to its full

length.

If the transmitter antenna is not

fully extended the operating

range of the radio will be re-

duced.

Check the transmitter antenna to be

sure it is not loose.

If the transmitter antenna works loose, or is discon-

nected while the model is running signal transmission

will be lost. This will cause you to lose control of the

model..

Always perform a operating range

check prior to use.

Problems with the radio control system as well as im-

proper installation in a model could cause loss of con-

trol.

(Simple range test method)

Have a friend hold the model, or clamp it down or

place it where the wheels or prop can not come in

contact with any object. Walk away and check to

see if the servos follow the movement of the con-

trols on the transmitter. Should you notice any ab-

normal operation, Do not operate the model. Also

check to be sure the model memory matches the

model in use.

Full

Length

1 2 3 4 5 6 7 8 9 10 11 ... 111 112

Comments to this Manuals

No comments

Futaba 3VCS User Manual Page 6

Comments to this Manuals

Related products and manuals for Accessories communication Futaba 3VCS