Futaba 3VCS User Manual download pdf (Page 90)

Functions

Throttle adjustment

(Preparation)

- In the state in which the throttle side is selected, select the ad-

justment screen by pressing the (SEL) button.

1 (Throttle neutral 5:5 adjustment)

Confirm that the cursor is pointing to the "NEUT5:5". Set

the neutral adjuster, which is located to the left of the

stick, to the upper side (5:5). Slightly tilt and release the

throttle stick, and then press the (SEL) button while

keeping away from the stick. If the neutral adjuster is not

properly positioned, the cursor does not move to the next

step.

2 (Throttle neutral 7:3 adjustment)

Confirm that the cursor is pointing to the "NEUT7:3". Set

the neutral adjuster, which is located to the left of the

stick, to the lower side (7:3). Slightly tilt and release the

throttle stick, and then press the (SEL) button while

keeping away from the stick. If the neutral adjuster is not

properly positioned, the cursor does not move to the next

step.

3 (Throttle throw adjustment)

In the throw setup screen (figure at the right) state, lightly

operate the stick fully to the brake side and forward side

and press the (SEL) button.

4 (Correction execution)

At the check screen (figure at the right), check if neutral

is near "0%" and the brake side and forward side throw

are near "100%" and press the (+) and (-) buttons simul-

taneously. Internal checks are performed automatically,

and when each adjustment point is within a fixed range,

correction is performed and "SUCCESSFUL!" (figure at

the right) is displayed.

If an adjustment point is not within a fixed range, an error

is displayed (figure at the right) and the correction data

are not updated.

5 (To abort execution, press the (END) button.)

When ending adjustment, return to the initial screen by

pressing the (END) button 3 times.

Adjuster/ADJUSTER

is displayed (figure at the right) and the correction data is

not updated.

4 (To terminate execution, press the (END) button.)

When ending adjustment, return to the initial screen by

pressing the (END) button 3 times.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 111 112

Comments to this Manuals

No comments

Futaba 3VCS User Manual Page 90

Comments to this Manuals

Related products and manuals for Accessories communication Futaba 3VCS