Futaba 8SGAP User Manual download pdf (Page 28)

•SERVO TEST FUNCTIONS

• The operation of the servos can be checked by

setting the transmitter and receiver power

switches to ON.

•When switch 49 is switched to TEST-A, the

servos move half-side first and then, come back

to neutral and repeat the other-half from chan-

nel 1 to channel 8. (Channel select switch (R)

48 to TEST-ALL position at this time.) The

servos set by the channel select switch do not

operate. (If set to 5, the landing gear servo does

not operate.)

•When switch 49 is switch to TEST-B, all the

servos operate linearly over their full travel.

(Channel select switch R 48 in TEST-ALL

position at this time.) Only the servos set at the

channel select switch are operated.

• The servo test is started by pressing button [46]]

and is stopped by pressing button 47.

Fig.

In this case, set switch [31] to the AUTO ACT

position. Rudder dual rate is then automatically

turned on and off with the throttle stick. Adjust

the throttle stick rudder auto dual rate ON and

OFF positions with trimmer [8].

VTR operation is the same as that for aileron dual

rate and elevator dual rate. Used it as desired.

Fig.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

No comments

Futaba 8SGAP User Manual Page 28