Futaba 8SGAP User Manual download pdf (Page 36)

•MUTUAL (BI-DIRECTIONAL)

MIXING (FLPRON, ELEVN, V-TAIL, DIFF)

Aileron + flap (FLPRON), aileron + elevator (ELEVN), rudder + elevator (V.TAIL), and aileron differential

(DIF) mixing can be selected with a switch.

FLPRON (AILERON + FLAP)

•This

function

allows

the

use

flaps

aircraft

with full length "strip" ailerons.

•

Use

a separate servo on each aileron and connect

as shown in Fig. 61 . NOTE: Always connect the

servo on the Right Aileron to CH1 (Aileron).

The Left servo to CH6 (Flap).

• Set Switches 16 and 17 as shown in Fig. 72.

• Aileron differential can be varied to suit using

Trimmer 15 . Trimmer 15 will vary the amount

of DOWN travel available on each aileron. UP

movement is not affected.

•The

Flap

function

can be operated by

using

the

Flap Knob 6 or better by using Switch 10 to

activate the Flaps and Elevator trim if necessary

(See Flap -> Elevator Down mixing Page 30).

• Elevator -> Flap mixing is possible by setting

trimmer panel Switch 10 to ACT and Control

Switch 12 to ON. (See Elevator -> Flap mixing

Page 30)

• Pitch trim in vertical maneuvers and point manu-

vers can be adjusted easily by using the Flap

Knob 6 .

• NOTE: When the ailerons are operated while in

the Flap DOWN mode, an additional downward

movement of the Aileron occurs. Wing tip stall

can occur easily if the Aileron is down too far.

prevent this, it may be necessary to use the

aileron differential (Trimmer 15) to reduce the

downward travel.

* Always connect the servo at the right wing to

receiver channel 1 (aileron).

Fig. 73

Fig. 72

Fig. 74

1 2 ... 31 32 33 34 35 36 37 38

Comments to this Manuals

No comments

Futaba 8SGAP User Manual Page 36

Comments to this Manuals

Related products and manuals for Accessories communication Futaba 8SGAP