Futaba 8SGAP User Manual download pdf (Page 13)

•TACHOMETER/TIMER OPERATION

LIQUID CRYSTAL DISPLAY

Do not press the keys too quickly.

Press them at a speed of about once

per second. |

Do not expose the display to direct sunlight

for a long time.

INTEGRATING TIMER

Blinks during counting

and stops blinking when

counting stops.

UP TIMER

DOWN TIMER

TACHOMETER

Fig. 13

This switch sets the alarm time in the UP TIMER

and DOWN TIMER modes. One minute is set each

time this key is pressed. If it is pressed and held for

two seconds or longer, the time is set in 5 minute

steps.

A beeping signal begins 10 seconds before the dot

time. A beep is produced every minute to indicate

the lapse of time.

This switch is used for memorization, starting,

stopping, and clearing in the UP TIMER and

DOWN TIMER modes. In the INTEGRATING

TIMER mode, this switch acts as the reset switch.

Switches the range when used as a

tachometer. LOW - 100 to 30,000 rpm.

HIGH -100to60,000 rpm

Tachometer/timer power switch.

is displayed at the mode selected at

the MODE SEL key switch

Selects the tachometer/timer mode.

The INTEGRATING TIMER mode is selected and

is displayed when the power is turned on,

The first time this switch is pressed, the UP TIMER

mode is selected and

is displayed.

The second time it is pressed, the DOWN TIMER

mode is selected and

is displayed.

The

third

time

pressed,

the

TACHOMETER

mode is selected and is displayed.

The fourth time this switch is pressed, the

tachometer/timer returns to the INTEGRATING

is displayed.

TIMER mode and

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Comments to this Manuals

No comments

Futaba 8SGAP User Manual Page 13

Comments to this Manuals

Related products and manuals for Accessories communication Futaba 8SGAP